Qaneh Qarehbagh Y, Jafari A, Hamidi E, Ashrafi gharyehali S A. Relating the dimensional parameters of the klystron tube resonator to one parameter and designing and optimizing the electrical parameters of the resonator using that parameter. Journal of Iranian Association of Electrical and Electronics Engineers 2024; 21 (3) :11-15
URL:
http://jiaeee.com/article-1-1594-en.html
Faculty of Electrical Engineering, Imam Hossein University
Abstract: (1203 Views)
In this article, the method of relating the dimensional parameters of the klystron tube resonator cavity to one of its parameters and then analyzing the cavity using this parameter is discussed. This new method makes it much easier to design and optimize the resonator. This method has been used to design a cavity for 3GHz frequency, so that after specifying a general parameter of the cavity and making other dimensions depend on it, and then using the sweep of this geometric parameter to check the changes in the electrical parameters of the design of the RF section including the resonance frequency , M and R/Q and then the effects on the output efficiency of the klystron tube has been studied using Mathematica and Microwave Studio CST software.
Type of Article:
Research |
Subject:
Communication Received: 2023/04/26 | Accepted: 2024/05/16 | Published: 2024/11/2
References
1. [1] P. Pankaj, Design OF RF Cavities and RF Section Of S Band Klystron.2014.
2. [2] R.K. Silva, and C.C. Motta. Design of multiple-beam klystron cavities. in IVEC 2012. 2012. IEEE. [
DOI:10.1109/IVEC.2012.6262074]
3. [3] P.D. Thakur,., et al., Design and Simulation of Cavity and RF Section for High Power (CW) Klystron. 2011.
4. [4] X. Xu, et al., G-Band Broad Bandwidth Extended Interaction Klystron with Traveling-Wave Output Structure. Electronics, 2022. [
DOI:10.3390/electronics11193153]